| This parameter gives the time in milliseconds, TurboPlayer waits when an element was stopped until the corresponding line/fader is closed by TurboPlayer. A little wait time is desirable to avoid that the end of an element might be cut off too early by the console. This parameter is also applied as delay time before TurboPlayer decides, whether a line must be closed if a new element might possibly start on the same line (e.g. because another channel is mixed to the same line or because another element is queued/joined on the same channel). Therefore, don't make this value too small or you risk to disturb the start of sequenced elements in some cases. As a general rule of thumb: do not make this value smaller than the value for OpenDelayActive. |